While you can manually move the laser to the correct position, then test the framing, I still would have liked a pair of endstops to easily set the 0 position by auto-homing. The ATOMSTACK A5 doesn’t have any endstops which I think is one of the biggest drawbacks for this laser engraver. You can download the ATOMSTACK A5 Manual from here. It starts with safety precautions, then continues with information regarding installation, software, recommended settings and materials. The information provided in the manual is good with excellent information for a beginner. Fortunately, a PDF was provided after contacting support. Unfortunately, my ATOMSTACK A5 laser engraving machine did not include a technical manual. I’m not sure if there’s even a need for a 32-bit like in the case of 3D printers, because this laser engraver is a much simpler machine with only dual axis control.Īs with most of the laser engravers available on the market, the ATOMSTACK A5 uses GRBL, a popular open source firmware for laser engravers. While other laser boards made the jump to 32-bit, the LaserBox 1.0 still has an 8-bit chip in the form of the ATmega328P. Instead, the laser has a fixed position and to focus the laser, you use a 2mm acrylic included in the box to set the offset from the item you want engraved. It’s a diode laser operating in the 455 nm spectrum and it does not have a focus ring like other machines. The real power output of the laser is 5-5.5W. The laser included is rated to 20W but this is the electrical power input. LaserGRBL, LightBurn, support Win XP / Win 7 / Win 8 / XP / Win 10 system. Protect the user’s eyes and prevent pets from grabbing the laser spot. All wood, bamboo, Paper, Plastic, Leather, PCB Board, Aluminum Oxide, Non-reflective plating and lacquered metalĬardboard, non-woven fabric, light wood, Acrylic material, thin plastic board
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |